The Challenge
In this article, we will continue from Part 1 of the Jack and Jill shower room series. In Part 1, we introduced the challenges faced with a Jack and Jill shower room, which is a shared shower room with two doors leading to two separate bedrooms. The first challenge is to prevent a tenant from entering the other tenant’s room, and the second challenge is to prevent a tenant from entering the shower while someone else is using it. In this article, we will walk you through the process of cutting holes in ceilings and wiring up electromagnets to address these challenges.
The Transformer
The first step was to site the transformer, which could need maintenance over time. I used an inspection panel to access the transformer quickly and this also mean I didn’t have to do much repair work on the ceiling. I marked up the location for the magnetic locks and used templates to help drill the holes in the doors. It is important to use rubber washers between the plate and the door for a good connection with the electromagnet.
Power Routing
Next, I drilled an angle through the frame to bring power to the locks and cut a hole in the ceiling for the lock switch. Before starting any work, it’s essential to isolate the power and check that the lights are off. The transformer is connected to the pull switch, which controls the 12-volt cables that go to the locks. I utilized the existing PIR (passive infrared sensor) in the bathroom to control the light.
In conclusion, in this article, we walked you through the process of addressing the challenges of a Jack and Jill shower room by cutting holes in ceilings, wiring up electromagnets, and utilizing existing equipment. Remember to isolate the power and take precautions before starting any electrical work.
